ip ospf cost (for a port)

Syntax

• default ip ospf cost

• ip ospf cost <0-65535>

• ip ospf port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} cost <0-65535>

Command Parameters

<1-65535>

Specifies the cost range.

port {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

Identifies the slot and port in one of the following formats:

• a single slot and port (slot/port)

• a range of slots and ports (slot/port-slot/port)

• a series of slots and ports (slot/port,slot/port,slot/port)

• all ports on the same slot (slot/all)

• all ports on the switch (all)

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

Default

The default is 0.

Command Mode

GigabitEthernet Interface Configuration